![]() If that uses something like the RFB protocol, then it might be similar to the VMware Video format.ĮDIT: In case it helps anyone, I've written a quick program in C to extract/dump the contents of the KEY chunks from the file: ( gist)ĮDIT: I've found that TeamViewer will happily play at least simple files consisting of just TVS\r\nBEGIN\r\nKEY.\r\nEND, stripping any other data.Īlthough I suppose it may well break if things like the Version or StreamTypes can affect the decoding. It might be just a recording of a TeamViewer session. There may be hope for decoding the format, but I couldn't see any efforts towards it. They seem to contain meaningful data in them, including a list of screen resolutions, a mouse cursor, and some 32-bit RGB image data, but the structure is not easy to discern. This command will bring you through the initial setup process, and allow you to connect your Teamviewer account to the Teamviewer for Raspberry Pi program. Step 1: In the Raspberry Pi SSH session, run the sudo teamviewer setup command. The binary data seems to contain several DEFLATE-compressed chunks. To configure Teamviewer on Raspberry Pi, follow the step-by-step instructions below. (The MetadataPosition marks the position after the END where the Base64 starts.) It contains a text-based header, a Base64 text footer, and a lot of binary data. ![]() A small amount of analysis can be found at. There doesn't seem to be a lot of information about it online.
0 Comments
Leave a Reply. |